Redpath Rollup Wall Motors/Gearboxes are simple to install, and easy to operate.

A roll up wall system will supply substantial control over the internal environment and may be adapted to most building designs.

A steel round guide tube (25.4mm O/D outer diameter) is located vertically through the roller guide of the winch itself and may be purchased as a separate part if you do not have this.

The roll up wall tube that runs the length of the wall horizontally and is turned by the Autowinder winch is a 25mm NB Pipe (33.3OD) pipe section – order as many as required for your length wall. The pipe is “swagged” at one end so that it may sleeve together, small ‘wafer head” screws will be needed to lock the joints together.

The other part of the roll up wall system is the “Polyclamp” grips – that secure the roll up wall material to the rolling pipe. (Allow a minimum of one Polyclamp per metre)

Redpath recommends Polyweave reinforced greenhouse film for the roll up wall sheeting (see below) + windbreak wall screening (see below) for the outer barrier netting, which may be used to hold the roll up wall against the greenhouse poles. If windbreak is not used, then some Polybelt webbed strapping will be needed to keep the roll up wall tight against the poles of the building.